NETGEAR DG834GV - Manual (Page 12)

Setup Manual for the DG834GV Integrated ADSL Modem and Wireless Router with Voice
1-8 Connecting the Router to the Internet
v1.0, February 2006
Computers Set to DHCP
For the initial connection to your router, your computer has to be set to automatically get its
TCP/IP configuration from the router via DHCP. This is usually the case. The NETGEAR Smart
Wizard CD automatically takes care of this requirement. For manual setup, refer to the
documentation that came with your computer.
Manually Setting Up Your ADSL Modem Wireless Router
There are four steps to setting up your ADSL modem wireless router:
6. Connect the router to the ADSL line via the ADSL microfilter with built-in splitter.
1. Install ADSL filters on other phone lines that use the same telephone number.
2. Log in to the router.
3. Connect to the Internet.
Follow the steps below to connect your router to your network. Before you begin, locate the ADSL
configuration information from your Internet Service Provider (ISP).
1. Connect the ADSL filter with built-in splitter, as follows:
a. Connect the Line port of the ADSL filter/splitter to the telephone wall socket.
b. Using telephone cable with RJ11 jacks, connect the ADSL port of the filter/splitter to the
ADSL port on the left rear of the ADSL modem wireless router
Note: If you purchased the DG834GV in a country where an ADSL filter is not
included, you must acquire one.