Nike Triax Elite HRM/SDM - Manual (Page 5)

5
3 1 2 4
3 1 2 4
Setup Positioning the HRM Transmitter and SDM Pod for Use
Follow steps through to position the HRM transmitter and SDM pod before a run or workout.
Push tab up
through slot in
HRM transmitter. Press down tab
until flush. Attach other side of HRM
transmitter around chest.
Position on rib cage just
below the breast plate.
The transmitter should be
worn directly against skin
and snug enough to stay
in place during workout. Generously wet both
sensors on the back
of the HRM transmitter
to ensure strong
connection between
your pulse and the
transmitter.
Remove the top
strap and unseat
the SDM pod from
the bottom clip. Loosen shoe laces
and slide pod clip
under laces. Secure the SDM pod
with black strap.
The pod should rest
just below where
laces tie and be
secure enough to
stay in place
during workout. Turn SDM pod ON.
Press and hold power
button until LED light
begins to blink.
NOTE: Press and hold
power button again to
turn pod OFF.