NEC LT84/LT140 - Manual (Page 11)

E–11
function remote control only.
6 Enter Button
Executes your menu selection and activates items selected from
the menu.
7 Magnify Button
Use the (+) or (–) button to adjust the image size up to 400%.
When the Pointer is displayed, the magnified image is displayed at
the center of the Pointer. When the Pointer is not displayed, the
magnified image is displayed at the center of the screen.
8 Pointer Button
Press this button to display one of the eight pointers; press again to
hide the pointer.
9 Picture Mute Button
This button turns off the image and sound for a short period of
time. Press again to restore the image and sound.
10 Help Button
Provides information about operation and adjustment procedures
or the set information for the current menu or adjustment during
menu operation. This also displays information how to use the Help.
Wireless Full Function Remote Control (Optional)
You can use your optional full function remote control wireless to
operate your projector.
With the mouse output port connected to your computer, you can
also use the projector’s remote control to operate your computer’s
mouse wireless. (See page E-16 to connect your computer to the mouse
output port.)
NOTE: If you are using a Macintosh computer, you can click either
the right or left button to activate the mouse.
11 Power On And Off
If power is applied, you can use this button to turn your projector
on and off.
NOTE: To turn off the projector, press and hold the POWER ON
button for a minimum of two seconds.
12 LED
Flashes when any button is pressed.
13 Computer/Projector Select
Use this button to switch between “Computer” and “Projector”.
When “Computer” is selected, the remote control works as your
computer mouse. In this mode only Mouse pad, Laser, R-Click
and L-Click buttons are available.
14 Laser Button
Press and hold this button to activate the laser pointer. When lit,
you can use the laser to draw your audience’s attention to a red dot
that you can place on any object within 30 feet (10 m).
15 Left Click Button
Use this button to enter your menu selection. It works the same as
the “Enter” button on the cabinet or the card remote control.
16 Laser Pointer
Beams a laser light when “Laser” button is pressed.
17 Infrared Transmitter
Direct the remote control toward the remote sensor on the projec-
tor cabinet.
18 Mouse Pad( ▲▼ ᮤ ᮣ )
Works as a mouse for your projected computer image. This pad is
also used to adjust position.
This pad selects the submenu you want to adjust.
After you make your on-screen menu selection, use this pad to
adjust the level up or down.
Remote Control Precautions
• Handle the remote control carefully.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• If you will not be using the remote control for a long time, re-
move the batteries.
• Do not place the batteries upside down.
NOTE: Before you use the card remote control for the first time, be
sure to remove the insulation tape from the card remote control.
* Keep the coin cell battery out of reach of children so as not to
allow them to swallow the cell battery.
Also observe the following when using the optional
full function remote:
• Do not look into the laser pointer while it is on.
• Do not point the laser beam at a person.
NOTE:
The optional full function remote control package (LT40RT) includes:
1) Full function remote control
2) Mouse adapter for Macintosh
3) Mouse adapter for IBM PS/2
4) Serial cable
5) Two batteries (AA)
6) Remote control case
The LT40RT optional remote control mouse kit can be obtained
from your dealer at additional cost.
17
16 15