Putting in the paper roll – NCR 7156 User Manual
Page 21
Advertising
7156 Setup and User’s Guide
Chapter 2: Setting Up and Using the Printer
September 1998
15
Putting In the Paper Roll
Note:
Tear off the end of the new roll so that the edge is loose.
1.
Place the new roll in the bin with a little extra paper extending over the front.
Be sure the paper unrolls from the bottom of the roll. Otherwise the paper will
not be printed on because the thermal coating will be on the wrong side.
2.
Close the receipt cover.
3.
Remove the excess paper by tearing it against the tear-off blade.
In addition to the tear off-blade, some printers use a knife to cut the receipt.
2
1
3
Advertising