NEC DLP CINEMA NC2500S - Manual (Page 46)

38
6. Appendix
Problem
The projector cannot be operated
with the remote control.
The STATUS indicator blinks in red.
An error code is displayed.
Check these items
Make sure the remote control transmission unit is facing the light reception unit on the projector.
Check whether the batteries are still good. Replace with new batteries.
Check whether there is any obstructing object between the remote control and the light
reception unit on the projector.
Check whether you are outside of the remote control's effective range (7m).
Check whether the remote control cable has become disconnected, if you are using the remote
control by connecting with the remote control cable.
Your projector may have trouble. Please contact your dealer/distributor for instructions.
See the "Error Code List" (page 40).
6-2. Indicator display list
See the descriptions below when the blinking or lighting of the two indicators on the projector’s control panel and the rear
STATUS indicator on the backside of the projector is observed. The projector also has a warning function that uses a buzzer.
MMS
STATUS
MMS STATUS indicator
POWER indicator
STATUS indicator
6-2-1. POWER indicator
Indicator condition
Off
Blinking light
Steady light
Projector condition
The main power is off.
The projector is getting ready to turn on.
The douser is closed.
The projector is cooling down.
The projector is turned on.
The projector is in standby.
Note
-
Wait for a moment.
Wait for a moment.
-
-
Green
Orange
Green
Orange
6-2-2. STATUS indicator
Indicator condition
Off
Blinking light (Red)
Projector condition
Normal
Error
Note
-
An error message is displayed in
the LCD screen. Check the content
of the error.