Nokia 930C - Manual (Page 5)

E
N
G
L
I
S
H
4 Nokia 930C
Quick Installation
1 Connect video cable(s)
Make sure both the monitor and computer
are powered OFF.
The monitor can be connected to one or two
computers using either the DB-15 video
cable (included) or a BNC video cable
(purchased separately). To toggle between
two computers: connect the DB-15 video
cable to the monitor and first computer, and
then connect the BNC video cable to the
monitor and the second computer.
Macintosh users: Models older than G3
require a Macintosh adapter. Attach the
adapter to the computer and plug the video
cable into the adapter.
To order a Macintosh adapter, contact your
dealer. See Customer Support in this user
guide.
2 Connect power cord
Connect the power cord from the monitor to
a properly grounded AC outlet.
3 Power-ON monitor and computer
Power-ON the monitor, then power-ON the
computer. This sequence (monitor before
computer) is very important.
NOTE: At this point Windows 98 users may
receive a message asking them to install the
930C INF file.
4 Install INF and ICM files
For CD-ROM: Insert the CD-ROM into the
CD-ROM drive, select “Monitor Drivers,”
and follow the on-screen instructions.
For diskette: Insert your diskette into the
diskette drive and run install.exe. Follow the
on-screen instructions.
5 Windows users: Set the Timing
Mode (resolution and refresh rate)
Example: 1600 X 1200 @ 85 Hz.
For instructions on changing the resolution
and refresh rate, see the user guide for your
computer's graphics card.
Installation is complete. Enjoy your new
930C monitor!
To be best prepared for any future customer
service needs:
Write the serial number (see back of the
monitor) in “For your Records” on page 1
of this guide.
Ports for optional
BNC video cable
Video cable
to computer
Power cords