Nokia DSL Gateway High-Speed Internet Connection - Manual (Page 19)

Physical installation
DN01154358 © Nokia Networks Oy 17 (40)
Issue 1-0 en Nokia Proprietary and Confidential
MW models only: connect the WLAN cards
1. Insert one WLAN card gently into the card slot located in the back panel of
the gateway.
2. Insert the other WLAN card(s) gently into the WLAN card slot(s) of your
PC(s).
Connect the gateway's power cable
1. Plug the gateway's power cord into the mains connector located in
gateway's back panel.
2. Connect the gateway's power cord plug into an earthed wall mains socket.
3. Switch on the power on your gateway.
Use filters if you want to use telephone and Internet simultaneously
Use in-line filters to block the high-frequency signals (data) from travelling
through the phone cord to your telephone, fax or answering machine. DSL and
HomePNA use the high bandwidth of your telephone line to transmit and receive
data.
Use approved filters only and install them according to the manufacturer's
instructions.
4.4 Installing an external WLAN antenna (MW series
only)
To obtain a better coverage for your wireless network, you can use external
antennas.
With Nokia C111 WLAN card, up to two external antennas can be used.
If you use only one external antenna, connect the external antenna to the right
antenna connector of the wireless LAN card. See figure 7.
Install the external antenna on the wall or on the ceiling according to figure 8. For
further information, refer to the WLAN card User's Guide.