NEC MT1000 - Manual (Page 31)

31
Settings Menu
Enables you to set preferences and other operating options. Use the “Select” button on the projector
cabinet or (▲) (▼) buttons on your remote control to access the submenu you want.
Custom Memory
This enables you to save your current settings for an RGB source in one of five memories, Custom
1-5.
To change the STANDARD settings, proceed as follows:
1. Connect your computer to the MultSync MT1000.
2. Select the "STANDARD" in RGB 1 or RGB 2 source.
3. Adjust the horizontal/vertical position, Picture, and Fine Picture adjustments.
4. Select the Custom Memory icon.
5. Press the "Adjust" (+) or (–) buttons to choose a memory location, then press "Enter" on the cabinet
or the "Left Click" on your remote control to save the new settings.
If you do not want to change the STANDARD settings, first select the Custom Memory icon, then
do the same as step 5.
Image Loop
This feature enables you to “capture” an image from a source that is currently being displayed. Up
to 8 images can be stored.
Press the “Adjust” (+) or (–) buttons to select "Start" for the image you want to loop and “Capture”
for the image you want to capture or to select “Delete” and delete all captured images from memory.
Press “Enter” on the cabinet or the “Left Click” on your remote control to save your image loop
changes. To stop an image loop, press one of the “Video”, “S-Video”, “RGB1” or “RGB2” button, or
using the Source menu.
Background
Use this feature to display a black or blue screen or to start an image loop when no input signal is
available.
Press the “Adjust” (+) or (–) buttons to choose the back screen you want — blue, black or an image
loop. Press “Enter” on the cabinet or the “Left Click” on your remote control to save your change.
Projection
This reorients your image for your type of projection. Press the “Adjust” (+) or (–) button until it is
correct. Press “ENTER” on the cabinet or the “Left Click” on your remote control to save your
change. The options are: front floor projection, rear ceiling projection, rear floor projection, and
front ceiling projection.
Language
Use the “Adjust” (+) or (–) to choose one of six languages for on-screen instructions. Press “ENTER”
on the cabinet or the “Left Click” on your remote control to save your change The options are:
English, German, French, Italian, Spanish and Swedish.
Reset
Changes all adjustments to the factory preset levels for each source individually. To activate, you
must hold down the “Adjust” (+) button on the cabinet or remote control for at least two seconds.
The adjustments that will be reset are horizontal and vertical control, picture and fine picture adjustment
(for the current source only), brightness, contrast, color, tint, and sharpness.
OPERATION
59
60