Nautique 100077 User Manual
Page 188
8-6
Section 8
Propeller
Removal
1. Remove the cotter pin from the propeller shaft and discard.
2. Wedge a piece of 1" x 4" wood between the propeller blade and
the starboard side of the strut and rudder.
3. Remove the nylon locknut and discard.
Use a propeller puller to remove the propeller, then remove the
key from the keyway. Inspect the keyways and key for any damage.
CORC047
A
B
C
• A propeller can be very sharp. Be careful when you
handle it. Wear a pair of protective gloves when
handling any propeller.
• Remove your key from the ignition and remove the
Emergency Stop Switch clip from the switch to
prevent accidental starting of the engine.
• DO NOT reuse the nylon locknut or the cotter pin.
• DO NOT use a damaged propeller. A damaged
propeller can damage your engine and boat.
CAUTION
D-Drive Sec 8_2010:Nautique Ski Sec 8.qxd 7/28/09 9:13 AM Page 8-6