NEC Express 320Fc Systems - Manual (Page 8)

-4-
Before Unpacking the System
•
Check the label or the packing slip on the outside of the
shipping box to verify that you received the correct shipment.
Depending on your order, you have received either a
rack-mountable system or a pedestal system.
•
Verify that the Tip-N-Tell and Shockwatch indicators on the
outer sides of the shipping box are not activated.
C A U T I O N
!
Do not unpack the system if you did not receive
the correct shipment, or if an indicator on the
shipping box is activated. Contact the shipping
carrier and the purchasing agent for your system
immediately.
Unpacking the System
Tools needed: A pair of scissors or a utility knife
1. Place the shipping box in the location where the system will be
installed, leaving it right side up on its shipping pallet.
2. Use the scissors or knife to cut the shipping straps and remove
them from the shipping box. To avoid injury while cutting each
strap, hold the strap firmly with one hand as you stand away
from it.
W A R N I N G !
To avoid eye or skin injuries, be careful when
cutting the straps from the box. The straps
can snap with considerable force when cut.