NeoDigits.com HVD2085 - Manual (Page 35)

Troubleshooting
Problem Possible Cause and Solution
No Power
Can not play Disc
No Picture
Picture distorted or loss of
color
No Disc / Wrong Disc
Can not display picture as full
screen
Can not select a chapter
Remote Control does not
work
No Sound
1. AC mains power is plugged in properly wit the socket and or player.
Ensure the power lead is firmly connected to the player and plugged
into the socket fully.
2. Switch the power on
1. Switch the power on.
2. The Disc type is not supported by the player or is seriously damaged.
Only use discs that can be played by this player
3. Wrong side of disc – place the disc on the tray with printed side
up.
4. Restriction of Disc level. Cancel the restriction.
5. Condensation on the laser lense. Switch on the player without any
disc loaded and allow to ‘Warm up’ for 1-2 hours.
1.The TV Video Input state is incorrect. Adjust the TV to AV/S-Video
/Component or HDMI depending on which player output is being
used.
2. Video output settings from player are incorrect for the TV / Display.
3. Damaged Media – clean the disc
1. The output settings of the DVD player are not matched with the
input settings of the TV / Display. Recheck both player and TV
settings
2. Damaged or poor quality media – clean or replace the disc
3. Connect the DVD player directly to the TV set.
The disc could be dirty or damaged. Please clean or replace the disc
1. Reset the display mode of the TV
2. Select the corresponding screen mode on the DVD player setting
menu
Some discs are disabled from selecting an individual chapter
1. Obstacle between the remote control and receiving window - point
the remote to the player directly – i.e. get a clear line of sight.
2. The remote control batteries have the wrong polarity or low power.
Please reload or replace the batteries
1. Check the TV or Amplifier equipment to make sure it is turned on.
2. The volume control has been set to minimum or has MUTE has
been turned on.
Note:
There is no audio output when the player is paused, in Step mode,
slow motion, FF or FR status.
32