Nokia GIGABIT TX TO SX TAP CVT-GCU/SX - Manual (Page 8)

Installation Guide for Gigabit TX/SX Tap
3
Figure.2 .
Connecting a GigaBit TX to SX Tap to the Network
.
1 ..Unpack.the.Tap.and.verify.that.you.have.all.components,.and.obtain.the.
required.cables.needed.to.successfully.install.the.unit .
2 ..Connect.Network.Port.A.to.the.appropriate.switch,.server.or.router.using.a.
CAT5E RJ45 straight-thru cable. This will act as your DCE interface.
3 ..Connect.Network.Port.B.to.the.appropriate.switch,.server.or.router.using.a.
CAT5E RJ45 straight-thru cable. This will act as your DTE interface.
4. Verify that the Tap Network Ports are cabled in-line between two devices.
Link Fault Signaling
. The.Tap.negotiates.separately.with.each.side.of.the.full-duplex.link,..
detecting.if.either.side.fails ..In.the.event.of.a.failure,.the.Tap.ceases.nego-
tiation.with.the.remaining.side,.enabling.a.clean.fail-over.to.a.redundant.
network connection (if one is available).
®
www.netoptics.com
Network
Monitor
1
2
GigaBit Converter Tap GigaBit Converter Tap
A
A
B
B
ACT LINK ACT LINK
LASER
CAUTION!
To network switch or router
To network switch or router