NEC MT830TM /1030TM - Manual (Page 13)

13
INTRODUCTION
23
24
5 RGB Input 2 Connector (Mini D-Sub 15 pin)
Connect a Macintosh or compatible computer here using the signal
cable and the monitor adapter that is supplied. Or connect your PC
or other RGB equipment such as IBM or compatible computers.
Use the signal cable that is supplied to connect to a PC.
RGB 2 Audio Input Mini Jack
This is where you connect a second RGB audio output from a
computer or another RGB source.
6 PC Control Port
Use this port to connect your PC to control the MultiSync MT830/
1030 Projector. This enables you to use your PC and serial commu-
nication protocol to control the projector. If you are writing your
own program, command references are on pages 99 to 102.
A cap is put on the port at the factory. Remove the cap when using
the port.
7 Mouse Output Port
Use this port to operate your computer’s mouse functions from the
NEC MultiSync MT830/1030 remote control. When your com-
puter is connected here, the remote sensors on the LCD projector
cabinet will receive your mouse commands.
8 Remote Control Jack
Connect your remote control cable here for wired operation.
9 Built-in Security Slot ( )
This security slot supports the MicroSaver ® Security System.
MicroSaver ® is a registered trademark of Kensington Microware
Inc. The logo is trademarked and owned by Kensington
Microware Inc.
PC CONTROL MOUSE OUTPUT REMOTE
CONTROL
INPUT
AUDIO R G B I N P U T 2 AUDIO R G B I N P U T 1
AUDIO R G B M O N I T O R O U T P U T
R L / M O N O
I N P U T A U D I O S – V I D E O
R L / M O N O
I N P U T A U D I O V I D E O
6 7 8
5
AC IN
9