Connecting an external monitor – NEC LT265 User Manual
Page 26
19
AUDIO
IN
PC CARD
R AUDIO IN L
AC IN
VIDEO IN
AUDIO OUT
S-VIDEO IN PC CONTROL
MONITOR OUT
COMPUTER 1 IN
COMPUTER 2 IN
AUDIO IN
USB
LAN
MONITOR OUT
AUDIO OUT
2. Installation and Connections
Connecting an External Monitor
You can connect a separate, external monitor to your projector to simultaneously view on a monitor the RGB analog
image you're projecting.
To do so:
1. Turn off the power to your projector, monitor and computer.
2. Use an RGB/VGA signal cable to connect your monitor to the MONITOR OUT (Mini D-Sub 15 pin) connector on
your projector.
3. Connect the supplied power cable. See page
4. Turn on the projector, monitor and the computer.
NOTE:
• The MONITOR OUT connector outputs an RGB signal during Standby mode.
• When the projector is in the standby mode, the image may not be correctly displayed while the cooling fans are running
immediately after turning on or off the power.
• Output sound level can be adjusted in accordance with the sound level.
• When audio equipment is connected, the projector speaker is disabled.
• Daisy chain connection is not possible.
RGB/VGA signal cable (supplied)
RGB/VGA signal cable (not supplied)
Audio cable (not supplied)
Audio cable (not supplied)