NuTone WIRELESS CHIME WITH STROBE LIGHT LA-204WH - Manual (Page 2)

+ –
6
5
4
3
2
1
SECURITY
CODE SETTING
TROUBLESHOOTING GUIDE
PREPARING THE RECEIVER
RECEIVER SECURITY CODING
Refer to Figure 5.
Changing the Security Code in not necessary unless you have
changed the security code in the Pushbutton. Both the
Pushbutton and Receiver codes must match.
1. Remove the screw from the code switch cover, then remove
cover.
2. Refer to Figure 6. Set the switch in the Receiver to match the
jumpers in the Pushbutton. The jumpers that are installed in
the Pushbutton must correspond to the switches set to the ON
position in the Receiver. For example, if jumper #1 is installed,
Switch #1 is in the ON position.
3. After setting the switches, reinstall the code switch cover
with screw.
MOUNTING THE RECEIVER
1. Plug the Receiver into any 120 volt wall outlet. Outlet must
be located within 100 feet of the Pushbutton.
O N 1
2
3
4
5
6
FIGURE 5
PROBLEM
1. Chime does not sound. • Check battery and polarity in Pushbutton.
• Make sure Pushbutton is not located on a
metal surface.
• Check that outlet on Receiver has power.
• Check Receiver and Pushbutton security
codes. These codes must match.
2. Chime is activated by another
wireless device.
• Change the security code in the
Pushbutton and Receiver.
These codes must match.
3. When Pushbutton button is
pressed, the incorrect chime
sound is heard.
• Check the sound code jumpers in the
Pushbutton.
SOLUTION
FIGURE 6
REMOVE
SCREW AND
COVER
JUMPERS
INSTALLED
ON 1, 3 & 6
1, 3 & 6
SWITCHES
SET TO “ON”
PUSHBUTTON
SECURITY CODE
SETTING EXAMPLE
RECEIVER
4820 Red Bank Road, Cincinnati, Ohio 45227
Printed in China, Rev. 4/05, Part No. 83044 Product specifications subject to change without notice.