NEC V28 0724-20 - Manual (Page 4)

6 7
Bit holder
TOOL ASSEMBLY
WARNING
To reduce the risk of injury, always
lock trigger or remove battery pack
before changing or removing acces-
sories. Only use accessories spe-
cifi cally recommended for this tool.
Others may be hazardous.
Removing Battery Pack from Tool
Push in the release buttons and pull the
battery pack away from the tool.
Inserting Battery Pack into Tool
The battery pack can be inserted into the
tool in two ways. To insert the battery pack
onto the tool, slide the pack onto the body
of the tool. Make sure it latches securely
into place.
For working in restricted
spaces, insert the battery
pack from the front of the
tool.
Fig. 1
Fig. 2
For optimum weight
distribution and balance,
insert the battery pack
from the back of the tool.
Installing the Side Handle
1. To install the side handle, loosen the
side handle grip until the ring is large
enough to slide over the torque selector
collar. The raised rib on the side handle
ring fi ts inside the groove around the
tool. Rotate the handle to the desired
position and tighten the side handle until
it is secure.
2. To remove the side handle, loosen the
side handle grip until the ring is large
enough to slide off the tool.
Clip-Lok TM System
The Clip-Lok system consists of three
pieces; the belt clip, the tool holder, and the
bit holder.
The system is shipped assembled for right-
handed use. To change the assembly for
left-handed use:
1. Remove battery pack.
2. Remove screws holding the tool holder
and the bit holder.
3. Lift the holders at the narrow end and
pull the front tangs out of their slots.
4. Replace the pieces onto the desired
side by sliding the tangs into the slots.
Tighten the screws securely.
Fig. 3
Attaching the Belt Clip
The belt clip can be mounted to tool belts,
bags, buckets, etc. To mount the belt clip:
1. Pull up the clamp release. The clamp
will pop out.
2. Slide the clamp over the tool belt, bag,
bucket, etc.
3. Press in the clamp to tighten.
Using the Clip-Lok Tool Holder
1. To attach the tool to the belt clip, slide
the tool holder over the stud on the belt
clip until it is held in place by the protrud-
ing pin.
2. To release the tool from the belt clip,
grasp the tool handle, push down on
the tool release lever with your thumb,
and pull up on the tool.
Using the Clip-Lok Bit Holder
The bit holder holds two standard 1/4" hex
shank bits up to two inches long.
1. Insert the bit by pressing it into the
clip.
2. Remove the bit by lifting the tip of the
bit and pulling it out of the clip.
Belt clip
Tool release lever
Stud
Pin
Clamp
Clamp
release
Tool holder
Front tangs