NETGEAR WNDA3100 - Manual (Page 38)

NETGEAR RangeMax Dual Band Wireless-N USB Adapter WNDA3100 User Manual
2-12
v1.0, December 2007
Setting Up WPA-PSK Security
To configure WPA-PSK security:
1. Run the WNDA3100 Smart Wizard.
a. Make sure that the WNDA3100 software is installed and the wireless USB adapter is fully
inserted in a USB port in your computer.
b. Use the icon to open the Smart Wizard. The Settings tab displays:
2. Configure the Security settings.
a. In the Profile field, select the profile, or type in a profile name.
b. In the Network Name (SSID) field, and then select the network, or enter the SSID.
c. In the Security section, select WPA2-PSK [AES], and enter the passphrase.
For more about WPA2-PSK, see the link to “Wireless Communications:” in Appendix B .
3. Save your settings in a profile.
a. Click the Save Profile button. All the configuration settings are saved in this profile.
b. Click Apply, and then click Close to exit the Smart Wizard.
Figure 2-9
Note: You will not get a wireless network connection unless the network SSID
matches exactly what is configured in the access point.