Fieldpoint banks – National Instruments FP-1001 User Manual
Page 42
FieldPoint Banks
Please use one page per FieldPoint bank.
Network module _____________________________________ Firmware revision ____________
Address __________________________________________ Baud rate __________________
Circle the state of the following items when your problem occurs:
LEDs POWER: ON/OFF NETWORK: ON/OFF ACCESS: ON/OFF STATUS: ON/OFF
SnapShot feature Enabled/Disabled
Watchdog timer Enabled/Disabled Timeout value ______ ms
Number of FieldPoint terminal bases ________________________________________________
Number of FieldPoint I/O modules __________________________________________________
Base
#
Module Name*
POWER
LED
READY
LED
Module Configuration Information
0
FP-1000/FP-1001
ON/OFF
ON/OFF
1
ON/OFF
ON/OFF
2
ON/OFF
ON/OFF
3
ON/OFF
ON/OFF
4
ON/OFF
ON/OFF
5
ON/OFF
ON/OFF
6
ON/OFF
ON/OFF
7
ON/OFF
ON/OFF
8
ON/OFF
ON/OFF
9
ON/OFF
ON/OFF
* If a terminal base is present but no module is inserted, write “none.”