NISSAN 2008 NAVIGATION SYSTEM - Manual (Page 76)

Black plate (78,1)
Model "NAV2-N" EDITED: 2007/ 3/ 9
4. Highlight the preferred route from the list
and push <ENTER>. The route to the
destination is set.
5. The selected destination is displayed at the
center of the map. Highlight [Start] after
confirming the location of the displayed
destination, and push <ENTER>. The
system sets the destination to the selected
location and starts calculating a route.
INFO:
. Even after setting a destination, you can
adjust the location of the destination, store
the location, etc.
“OPERATIONS AFTER SETTING A
DESTINATION” (page 4-24)
. The stored route includes only locations
(destination and waypoints) and route cal-
culation conditions, not the route itself.
Therefore, when the destination is set using
a stored route, a different route may be
suggested if the current vehicle location is
different from the one when the route was
stored.
SETTING BY PHONE NUMBER
If you know the telephone number of the facility,
use this to find the facility by entering the
number, and then have the system calculate a
route.
INFO:
. Telephone numbers that were stored for
stored destinations can also be used.
. If the area code of the specified telephone
number does not exist in the map data, the
system will not search for the location.
. Only the locations included in the database
in the map data can be searched by the
phone number. Personal phone numbers
cannot be used to search for a location.
1. Push <DEST>.
2. Highlight [Next Page] and push <ENTER>.
3. Highlight [Phone Number] and push
<ENTER>. The telephone number input
screen is displayed.
4-18 Setting a destination