Napoleon Fireplaces GVFS60-P - Manual (Page 8)

8
W415-0204 / C / 10.02.01
LOG PLACEMENT INSTRUCTIONS
Blocked burner ports can cause an incorrect flame pat-
tern, carbon deposits and delayed ignition. PHAZER
TM logs
glow when exposed to direct flame and provide a unique
and realistic glowing effect. Use only certified PHAZER
TM
logs available from your Napoleon / Wolf Steel Ltd. dealer.
Place log #1 onto the burner, centering it onto the burner
tray and pushing it as close to the rear wall of the firebox
as possible. Move logs # 2 and 3 into position, lining up
the studs located on the burner with the holes on the bot-
tom of the logs. Sit the notch at the bottom of log #4 against
the left outermost grate post and position the top of the log
into the pocket provided on the rear log (#1).
The notch in log #5 should be pressed down onto the
skewering pin located at the end of the grate as shown to
prevent it from rocking.
Position the notch located in log #6 against the grate post.
Place the bottom of log #7 against the right outermost
grate post and the top into the pocket provided on the center
log (#6). Tear the glowing embers into pieces and place
onto the front of the burner. Care should be taken to shred
the embers into thin, small irregular pieces as only the
exposed edges of the fibre hairs will glow when exposed
to direct flame; however care should be taken to not block
the burner ports. Blocked ports can cause an incorrect
flame pattern, carbon deposits and delayed ignition.
Log colours may vary. During the initial use of the fire-
place, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
POSITIONING THE LOGS IMPROPERLY WILL CAUSE
FLAME IMPINGEMENT AND CARBONING.
#6
3
#3
#1
#4
1
#2
#5
FIGURES 8a-d
#7
4
2