Nady Systems SPM 6600/8600 - Manual (Page 5)

INSTALLATION
5
To ensure years of enjoyment from your NADY AUDIO SPM 6600/8600 powered mixer, please read and understand this manual
thoroughly before using the unit.
1. INSPECTION
Your NADY AUDIO SPM 6600/8600 was carefully packed at the factory in packaging designed to protect the units in shipment. Before
installing and using your unit, carefully examine the packaging and all contents for any signs of physical damage that may have
occurred in transit.
[Please note: Nady Systems is not responsible for shipping damage. If your unit is damaged, do not return to Nady, but notify your
dealer and the shipping company (if shipped to you) immediately to make a claim. Such claims must be made by the consignee in a
timely manner.]
2. SETUP AND OPERATION
Parts of the unit can become very warm during use. This is normal during operation. Care should be taken to ensure that there is
enough space around the unit for cooling. Also, do not place the SPM 6600/8600 on high temperature devices such as power
amplifiers, etc., or the unit may overheat in operation.
Although the unit’s chassis is shielded against radio frequency (RF) and electromagnetic interference (EMI), extremely high fields of RF
and EMI should be avoided.
Please make sure that the power unit supplied is marked for the correct voltage in your area (120VAC/60 Hz or 230VAC/50 Hz). Power
requirements for electrical equipment differ from area to area. In new installations and portable sound systems, or any situation in which
the AC power is in question, it is wise to confirm the voltage and use the appropriate power supply unit before connecting it to power
sources.
Europe (except UK): 230V, 50Hz
UK and Australia: 240V, 50Hz
USA and Canada: 120V, 60 Hz
For other areas, please check with local authorities.
When ready to operate, plug the AC cord into the power source. Make sure that the unit is turned off before connecting to the AC power
source to avoid possible loud transients which can damage your speakers or your ears. Set the noted controls to the positions indicated
below to further minimize the chance of undesired noise when first powering up your SPM 6600/8600 :
LEFT/RIGHT & MAIN MONITOR CONTROLS (12,24,26) ............................................................................................ SET TO MINIMUM
HI, MID & LOW EQ’S (5) AND PAN/BALANCE CONTROLS (1) ................................. TURNED TO THE CENTER DETENT POSITION
DSP EFFECT ON/OFF SWITCH (14) ..................................................................................................................................... SET TO OFF
Power up the unit as noted on page 10 and 11.