Napoleon Fireplaces EF30 - Manual (Page 11)

11
W415-0675 / A / 03.28.08
OPERATING BY REMOTE CONTROL
1. Plug in your electric fi replace.
2. Make sure the unit's main Power ON/OFF button is at
the ON position! The remote control will NOT work if the
main Power button is at the OFF position.
3. When operating the remote control, it must be directed
towards the front of the unit.
4. The button at the top left corner of the remote is the main
ON/OFF
power button. Pressing this button activates
t h e p o w e r to the unit.
5. To adjust the ember bed brightness, press the “+” or
“-” buttons. To increase the ember bed brightness, press
the “+” button, to decrease the ember bed brightness,
press the
"-" button. There are seven levels of bright-
ness.
6. To activate the fireplace, press
the button. Press
and release the button to cycle through LO, MED, HI
and OFF. Each time the button is pushed, the Fireplace
LED will change to its corresponding color: Green for LO,
Orange for MED, Red for HI, and blank for OFF. The fi re-
place has a built-in thermostat so it will shut off automati-
cally once the pre-set temperature is reached. It will also
turn on automatically if the room temperature drops below
the pre-set temperature.
7. To adjust the height of the fl ame, press the “+” or “-” but-
tons. To increase the height of the fl ame, press
the “+”
button, to decrease the height of the fl ame, press the "-"
button. There are seven levels of fl ame effects.
8. To turn off the fi replace, press the ON/OFF button
once. NOTICE: This remote control must remain
within 8 meters or 26 feet of the fi replace to be effective.
The controls (see Figure 8) are located on the bottom right
corner of the unit.
1. Plug in your electric fi replace.
2. Main ON/OFF Power Switch and LED:
This switch is located on the right side of the control panel.
The "|" indicates ON and "O" indicates OFF.
When the unit is fi rst turned on, the default settings are as
follows:
- Ember bed: HIGH
- Flame: HIGH
- Fireplace: OFF
3. Temperature Control Button and LED:
The FIREPLACE LED is located to the right of the FLAME
Button. Push the TEMP button to cycle through different
fi replace settings. Press and release the TEMP button to
cycle through LO, MED,HI and OFF. Each time the TEMP
button is pushed, the FIREPLACE LED will change to its
corresponding color: Green for LO, Orange for MED, Red
for HI, and blank for OFF. When the fi replace is turned on,
heat will emit through the vents located in the middle of the
top louvre panel (see Figure 13). The fi replace has a built-in
thermostat so it will shut off automatically once the pre-set
temperature is reached. It will also turn on automatically if
the room temperature drops below the pre-set temperature.
NOTE: When the fi replace is turned on for the fi rst time, it
may release a slight, harmless odour. This odour is a normal
occurrence caused by the initial heating of the internal heating
elements and should not occur again.
4. Flame Control Button:
This button is located to the right of the TEMP Button (see
Figure 12). After power is turned on, push the FLAME control
button to adjust the fl ame and ember bed brightness. Press
and release the Flame Control Button to cycle through LO,
MED,HI and OFF.
NOTE:
Make sure your batteries are fully charged and installed
correctly in your remote control.
OPERATING INSTRUCTIONS
FIGURE 12
FIGURE 13