NEC LT154 - Manual (Page 19)

E – 16
2. INSTALLATION
This section describes how to set up your MultiSync LT156/LT155/LT154 projector and how to connect video and audio sources.
Setting up Your Projector
Your MultiSync LT156/LT155/LT154 Projector is simple to set up and use. But before you get started, you must first:
1. Determine the image size.
2. Set up a screen or select a non-glossy white wall onto which you can project your image.
Ensure that the power cable and any other cables connecting to video sources are disconnected before moving the projector.
When moving the projector or when it is not in use, cover the lens with the lens cap.
Selecting a Location
The further your projector is from the screen or wall, the larger the image. The minimum size the image can be is approximately 25" (0.6 m)
measured diagonally when the projector is roughly 3.7 feet (1.1 m) from the wall or screen. The largest the image can be is 300" (7.6 m) when the
projector is about 40.1 feet (12.2 m) from the wall or screen.
Screen and Projection Distance
The following shows the proper relative positions of the projector and screen. Refer to the table to determine the position of installation.
Throw distance
Screen size (Unit: cm / inch)
Screen
81.3 (W) X 61.0 (H) / 32 (W) X 24 (H)
61.0 (W) X 45.7 (H) / 24 (W) X 18 (H)
TELE: 25"
50.8 (W) X 38.1 (H) / 20 (W) X 15 (H)
Lens center
121.9 (W) X 91.4 (H) / 48 (W) X 36 (H)
60"
162.6 (W) X 121.9 (H) / 64 (W) X 48 (H)
80"
203.2 (W) X 152.4 (H) / 80 (W) X 60 (H)
100"
243.8 (W) X 182.9 (H) / 96 (W) X 72 (H)
120"
304.8 (W) X 228.6 (H) / 120 (W) X 90 (H)
150"
406.4 (W) X 304.8 (H) / 160 (W) X 120 (H)
200"
487.7 (W) X 365.8 (H) / 192 (W) X 144 (H)
240"
40"
27"
548.6 (W) X 411.5 (H) / 216 (W) X 162 (H)
WIDE: 300"
609.6 (W) X 457.2 (H) / 240 (W) X 180 (H)
270"
1.1/3.6
1.7/5.6
2.6/8.5
3.5/11.5
4.3/14.1
5.2/17.1 6.5/21.3
8.7/28.5
10.5/34.4 12.2/40.0
Distance (Unit : m / feet)