Niles Audio SVL-6 - Manual (Page 12)

Operation
There are two ways to use the SVL-6. You may play and
adjust the volume of one pair of speakers at a time, or play
multiple pairs simultaneously.
If you intend to play more than one pair of speakers at the
same time, you will need to become familiar with the oper-
ation of the SVL-6's PROTECTION button.
Playing One Pair of Speakers At a Time
1. Make sure the amplifier or receiver power is OFF and set
the volume to minimum.
2. Set the SVL-6 volume control for the speaker pair you
wish to play to maximum (fully clockwise).
3. Locate the ON/OFF button on the SVL-6 which corre-
sponds to the speaker pair you wish to play. Set it to the
ON position.
4. Turn on the amplifier or receiver and select as source,
such as the tuner or CD player.
5. Slowly turn up the amplifier or receiver volume and set it
to a comfortable (not maximum) listening level. Be careful
not to overdrive or "clip" your amplifier. If the sound
becomes muddy or distorted, you have reached the limit of
your amplifier's volume capability and should quickly reduce
the volume to avoid damaging your speakers.
S
P E A K E R
S
E L E C T I O N
/ V
O L U M E
C
O N T R O L
S
Y S T E M
1
1
"TECH TIP"
If your amplifier or
receiver has "A"
and "B" speaker-
pair outputs,
connect the SVL-6
to the "A" outputs.
Do not connect
anything to "B".
This will prevent
the amplifier or
receiver from
driving an
unusually low
impedance load.