NETGEAR FA510 - Manual (Page 4)

Model FA510 Network Card Installation Guide
1. Using a UTP cable, connect any port on the hub to the port on the RJ-
45 adapter cable.
2. To connect the network cables, follow the illustration below.
Note: One of the ports on NETGEAR hubs is switchable between
Normal (MDI-X) and Uplink (MDI) with a Normal/Uplink push
button. If you are using this switchable port on a NETGEAR hub to
connect to a PC or the network card, make sure the Normal/Uplink
push button is set to Normal.
Connect the Network Cables
9026FA
RJ-45
connectors
PC with network
card installed Power adapter Notebook PC
*Use the cable provided or any Category 5 UTP cable.
Maximum length = 100 meters (300 feet)
Category 5 10/100 Mbps UTP cables*
Model FA510
Network Card with
RJ-45 adapter cable
Hub