NAD C 445 - Manual (Page 7)

7
REAR PANEL CONNECTIONS
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
1 FM Antenna: Connect an indoor or external FM antenna to this
terminal.
2 AM Antenna: Connect the AM loop antenna supplied with the
C445 Tuner to these terminals. If an external AM antenna is used,
make connections to the AM and GND terminals in accordance with
the instructions supplied with the antenna.
3 Analogue Audio Outputs: Connect these jacks to the tuner input
of your pre amplifier or integrated amplifier for analogue audio
playback. Be certain to observe proper channel connections using
the colour-coded cables and connectors so that red connects right
channels and white connects left channels.
NOTE: Before making any audio connections, unplug all components of
your audio system from their AC power outlets. To reduce the
possibility of hum or noise in your system, place all audio
interconnection cables away from both AC power cords and speaker
wires.
4 Optical Digital Output: Connect this jack to the optical digital
input of your pre amplifier or integrated amplifier, if available.
Note that this digital output only contains the digital signal from the
DAB stations. For FM/AM reception, you will have to connect the
analogue outputs at all times.
5 DAB Antenna: Connect a DAB antenna to this terminal.
6 AC Power Cord: Connect this plug to an AC outlet. If the outlet is
controlled by a switch, make certain that it is in the ON position.
Introduction
C445_eng_v03.qxd 2/24/2006 9:14 AM Page 7