Nikon S610 - S610c - Manual (Page 29)

17
Charging the Battery Using the AC Adapter (COOLPIX S610c)
First Ste
p
s
The following chart explains power-on lamp status of the COOLPIX S610c while the AC
adapter is connected.
6
Disconnect the camera and AC adapter when charging is complete.
Turn the camera off.
Disconnect the AC adapter from the camera’s multi connector and unplug the power
cable from the power outlet.
C
Note on the AC Adapter
• Be sure to read and follow the warning for the AC adapter on page ii.
• Be sure to read the section, “The Battery” ( A 119), thoroughly before use.
• Do not, under any circumstances, use another make or model of AC adapter. Failure to observe
this precaution could result in overheating or in damage to the camera.
• Do not connect the power cable supplied with the AC Adapter EH-63 to any other device.
C
The AC Adapter EH-63
The AC Adapter EH-63 (supplied) can:
• When the camera is turned on, power the camera from a power outlet.
• If you are using the COOLPIX S610c, the battery inserted into the camera is charged when the
camera is turned off with the AC adapter connected.
• If you are using the COOLPIX S610, the AC Adapter EH-63 is not supplied with the camera.
Furthermore, the battery cannot be charged while it is inserted into the camera.
• The AC adapter and the supplied audio/video cable or USB cable cannot be used at the same
time.
C
The Battery Charger MH-65
If you are using the COOLPIX S610c, the Battery Charger MH-65 ( A 116), for charging a
Rechargeable Li-ion Battery EN-EL12, is available separately.
Power-on lamp Description
Blinks (orange) Battery charging.
On (orange) Battery fully charged.
Off/Blinks (green)/
On (green)
The camera is on. Turn the camera off when charging.
Flickers (orange)
• Charge the battery indoors with an ambient temperature
of 5 °C to 35 °C (41 °F to 95 °F) before use.
• If the lamp flickers rapidly, the AC adapter is not correctly
connected or there is a problem with the battery.
Reconnect the AC adapter or replace the battery.