NetComm NP3024 - Manual (Page 19)

YML711 Rev1 NetComm 16 or 24 port Gigabit Switch
www.netcomm.com.au 19
Device Setting
The Device Setting panel allows you to control the configuration of your new Switch.
Configuration Setting: The Configuration Setting allows you to set the IP
Address, Subnet Mask, Gateway, Set Trap to (Trap IP
Address), System name and Location.
Select the device in the Discovery list or Monitor List and
the click on the Configuration Setting button. The
Configuration Setting window will be displayed (refer to
Figure 9). After completing the details, type a password
and press the “Set” button to apply the changes.
Figure 9. Configuration Setting
Password Change: The password can be changed by clicking on the
“Password Change” button. Enter the original password
and the new password and confirm it. Click on the “Set”
button to apply the change.
Figure 10. Password Change