Nordmende 2401935EN0801 - Manual (Page 12)

6.1 Start-up
Prior to starting the unit up, check the correct connections of the steam pipe, water feed pipe, drainage pipes and
electrical cables.
Open the shut-off valve in the water feed pipe and switch the unit on with the black power switch.
As soon as the demand for steam is recognised, the green LED lights up, the contactor is activated and , soon after,
water is let into the steam cylinder. As soon as the electrodes in the cylinder are covered with water, it is being
heated and the fully automatic operation commences.
During the start-up phase, or after a new replacement cylinder has been fitted, the maximum water level can be
attained. When Niveau max. has been reached, the inlet valve closes. This is a normal occurrence during the steam
cylinder’s concentration phase. The length of this phase can differ, it lasts until the cylinder has reached the nominal
rating. When the Niveau max. is attained it will be indicated by a red flash in the green colour of the LED.
6.2 Setting the output limitation
The steam output can be set step less from 20 % to 100 %
capacity. For setting the output limitation the electric
compartment must be opened and the potentiometer on
the electronic print must be adjusted. Turning clockwise
increases the steam output and turning anticlockwise
reduces the steam output. The output ex works is set at
100 %.
6.3 LED Display
The electronic controls unit of the econoVap monitors the operation of the humidifier continuously.
All operating conditions and system indications are shown with the two-colour LED. The status of the LED can be
shining continuously or flashing in the red and green colours.
12
6 Putting the humidifier into operation
Button “manual drainage”
Coding switches
Potentiometer
Fig. 6.1