Braun 1507 - Manual (Page 7)

7
4 Keeping your shaver in top shape
4.1 Cleaning
•
After shaving, switch the shaver off. Remove the foil frame 2 (d) and gently tap it
out on a flat surface.
• Then thoroughly clean the cutter block with the brush. About every four weeks,
clean the cutter block with Braun cleaning agents.
• Do not clean the shaving foil with the brush.
• If you have a very dry skin and you notice a reduced operation time of the shaver,
you should put a drop of sewing machine oil onto the shaving frame.
4.2 Changing the shaving parts
•
To maintain optimum shaving performance, we recommend to replace the shaving
frame and the cutter block every 1
ó year or when these parts are worn.
• Pull off the foil frame (d). Replace the new foil frame in the right direction until it locks
in place.
• To remove the cutter block, set it in crosswise position and lift it off (f). To replace
the cutter block, snap onto the holding studs.
4.3 Preserving the cell unit
•
In order to maintain the capacity of the cell unit, the shaver has to be discharged by
shaving every 6 months approximately. Then recharge the shaver to full capacity
again.
• Do not expose the shaver to temperatures of more than 50 °C for longer periods of
time.
5 Environmental notice
This appliance is provided with a nickel-hydride cell unit.
This cell does not contain any harmful heavy metals. Nevertheless, please do
not dispose of this appliance in the household waste at the end of its useful
life. Disposal can take place at a Braun Service Centre or appropriate collec-
tion sites. However, if you prefer to dispose of the cell unit yourself, remove
the cell unit as shown on page 52.
Subject to change without notice.
This product conforms to the EMC-Requirements as laid down by the
Council Directive 89/336/EEC and to the Low Voltage Regulation
(73/23 EEC).
5597182_S.4-54.fm Seite 7 Donnerstag, 9. August 2001 3:09 15