Compatible and related netgear products, System requirements, Autosensing ethernet connections with auto uplink – NETGEAR ProSafe WAG102 User Manual
Page 4
Reference Manual for the NETGEAR ProSafe Dual Band Wireless Access Point WAG102
2-4
Introduction
v1.0, September 2005
Autosensing Ethernet Connections with Auto Uplink
The WAG102 can connect to a standard Ethernet network. The LAN interface is autosensing and
capable of full-duplex or half-duplex operation.
The wireless access point incorporates Auto Uplink
TM
technology. The Ethernet port will
automatically sense whether the Ethernet cable plugged into the port should have a ‘normal’
connection such as to a computer or an ‘uplink’ connection such as to a switch or hub. That port
will then configure itself to the correct configuration. This feature also eliminates any concerns
about crossover cables, as Auto Uplink will accommodate either type of cable to make the right
connection.
Compatible and Related NETGEAR Products
For a list of compatible products from other manufacturers, see the Wireless Ethernet
Compatibility Alliance We
).
The following NETGEAR products work with the WAG102 Access Point:
•
WAG511 ProSafe 108 Mbps Dual Band PC Card
•
WAG311 ProSafe 108 Mbps Dual Band PCI Card
•
WG311T 802.11g 108 Mbps Wireless PCI Card
•
WG511T 802.11g 108 Mbps Wireless CardBus Adapter
•
WG511 802.11g 54 Mbps Wireless CardBus Adapter
•
WG111 801.11g 54 Mbps Wireless Bridge
System Requirements
Before installing the WAG102, make sure your system meets these requirements:
•
A 10/100 Mbps Local Area Network device such as a hub or switch
•
The Category 5 UTP straight through Ethernet cable with RJ-45 connector included in the
package, or one like it
•
A 100-240 V, 50-60 HZ AC power source
•
A Web browser for configuration such as Microsoft Internet Explorer 6.0 or above, or
Netscape Navigator 4.78 or above
•
At least one computer with the TCP/IP protocol installed
•
802.11b or 802.11b-compliant devices, such as the NETGEAR WG511 Wireless Adapter