Before each use, Step 2. add fuel(s) – North Star M157594I User Manual

Page 20

Advertising
background image

Before Each Use

20

Never attempt to repair a high-pressure hose or component – Always
replace it with a part that is rated at or above the pressure rating of this
machine.

1) Check hoses, fittings, wand, trigger gun and connections for signs of wear,

cracks, looseness, or leaks. Replace as required.

2) Check and clean the nozzle orifice.
3) Clean inlet filter. (See Maintenance instructions)

Inspect fuel
system

Always inspect (engine and burner) fuel systems & check for leaks
BEFORE starting pressure washer.
Do not start pressure washer until all needed repairs have been completed.

WARNING

: Fuel leak hazard

Gasoline and burner fuels are highly explosive and fuel leaks can result in
fire or explosions. You can be burned and seriously injured if the fuel
system is not properly hooked up or there is a fuel leak when you start the
engine.

Inspect the entire fuel system. Look for:

signs of leaks or deterioration,

chafed or spongy fuel hose,

loose connections,

loose or missing fuel hose clamps,

damaged gasoline tank, or

defective gasoline shut-off valve.

Perform other
scheduled
maintenance as
needed

Make sure that any other regular maintenance has been performed as
prescribed in this manual in the "Maintenance & Repair" section.

1. Refer to the engine owner's manual for engine maintenance instructions.

2. Make sure battery is charged. Charge as needed according to your battery

manufacturer's instructions.

Step 2. Add Fuel(s)

WARNING: Fuel fire/explosion hazard

Gasoline is highly flammable and explosive. Burner fuels are
combustible at warm temperatures. Heat, sparks, and flames can
ignite fuel vapors, which can become widespread during fueling. A
flash fire and/or explosion could result and cause serious injury or
death. Always use extreme care when handling fuels. Carefully
follow all instructions to avoid the following conditions which could
result in fuel ignition:

gas vapor collection inside enclosures

static electric sparks

sparks from electric wiring, batteries, or running engines

sources of heat (such as a hot engine, burner or exhaust)

open flames, including pilot lights

Advertising