Nortel Networks Voice Mail User Manual
Norstar voice mail voice channel upgrade guide
Advertising
Table of contents
Document Outline
- Norstar Voice Mail
- Voice Channel Upgrade Guide
- Norstar Voice Mail Voice Channel Upgrade
- Upgrading Voice Channels on a system equipped with DVCs
- Upgrading Voice Channels on a system equipped with a BIC
- Installation overview
- Checking the number of Voice Channels currently installed
- 1. Press ƒ · ⁄ fi.
- 2. Enter the default password ¤¤¤‹‡‡¤ (ACCESS2) and press £.
- 3. Press NEXT until the display shows:
- 4. Press SHOW.
- 5. Press ALL to view the number of Voice Channels currently installed on your system.
- 6. In this display there are four Voice Channels installed on the system. Refer to Table 3 on pag...
- 7. To end this session, press ® .
- Table 3 Voice Channel Symbols
- Enabling the Voice Channel Upgrade Security Key Code
- Verifying the number of Voice Channels requested
- Determining your internal NorstarVoiceMail system serial number
- 1. Press ƒ · ⁄ fi .
- 2. Enter the default password ¤¤¤‹‡‡¤ (ACCESS2) and press £ .
- 3. Press ADMIN .
- 4. Press NEXT until the display shows:
- 5. Press SHOW to view the internal NorstarVoiceMail system serial number.
- 6. After you have recorded the internal serial number, press OK .
- 7. To end this session, press ® .
- Completing the Upgrade Information Sheet
- Getting your Security Key Code
- Enabling the Voice Channel Upgrade Security Key Code
- 1. Press ƒ · ° ‹.
- 2. Enter the System Coordinator Mailbox number and password and press OK.
- 3. Press › ›.
- 4. Press ADD.
- 5. Enter your Voice Channel Upgrade Security Key Code and press OK .
- 6. After the additional Voice Channels are enabled, you should back up the NorstarVoice Mail mod...
- 7. Press ® to end this programming session.
- Backing up the capabilities file
- 1. Press ƒ · ⁄ fi .
- 2. Enter the default password ¤¤¤‹‡‡¤ (ACCESS2) and press £ .
- 3. Press ADMIN .
- 4. Press NEXT until the display shows:
- 5. Press SHOW .
- 6. Press BCKP .
- 7. Insert the IBM formatted floppy diskette into the floppy disk drive on the NAM and press OK .
- 8. Press OK .
- 9. To end this session, press ® .
- Rebooting the NAM
- 1. Press ƒ · ⁄ fi .
- 2. Enter the default password ¤¤¤‹‡‡¤ (ACCESS2) and press £ .
- 3. Press NEXT until the display shows:
- 4. Press SHOW .
- 5. Press GRACE to perform a Graceful reboot. Press NEXT to reach the Quick reboot display.
- 6. Press YES . The display changes to show:
- 7. To end this session, press ® .
- Upgrade Information Sheet
- Norstar Voice Mail Voice Channel Upgrade