NEC Attendant Xen IPK - Manual (Page 12)

10
Conference Bridge Setup
Before using the Multiline Conference Bridge feature, passwords must
be assigned. It should be noted that the supervisor should perform these
procedures.
SETTING SUPERVISOR PASSWORD
Call a Conference Bridge extension.
When the Conference Bridge extension answers, dial the default
Supervisor Password (0000#).
Follow the voice prompt and enter the setting verification mode.
Then enter setting change mode.
Follow the voice prompt to change Supervisor Password (4-8 digits).
SETTING CONFERENCE 1 AND/OR CONFERENCE 2 PASSWORDS
Set the Supervisor Password, if necessary.
Call a Conference Bridge extension.
When the Conference Bridge extension answers, dial the Supervisor
Password and #.
Skip the steps by pressing * until the Conference Setup mode is
available for conference 1 or conference 2.
Follow the voice prompt and set the conference 1 or the conference 2
password (4-8 digits).
RECORD CUSTOMISED GREETING
Set the Supervisor Password, if necessary.
Call a Conference Bridge extension.
When the Conference Bridge extension answers, dial the Supervisor
Password and #.
Press * to skip the setting verification mode.
Press # to change system settings.
Skip the steps until Customised Greeting option is played.
Follow the voice prompt and record a new Customised Greeting.