Nikon Monarch X 4-16x50 SF - Manual (Page 5)

8 9
(3) Magnification
(1) The riflescope 2.5-10x44 SF have a variable magnification from 2.5 to 10x, 4-16x50 SF from 4 to 16x.
(1) To change powers. just rotate the power selector ring until the desired magnification appears adjacent to the power index dot.
(4) Adjustment and zero setting of the riflescope
(1) Sighting through the riflescope, align the rifle with your aiming point on the target and shoot a trial round. If the bullet does not hit the aiming point, adjust the elevation and
windage. as follows:
(1) If the bullet hits under the aiming point, turn the elevation adjustment (counter-clockwise) in the direction of the arrow marked "UP" for up as in Fig. 3-5. If the bullet hits high,
turn adjustment (clockwise) in the opposite direction of the arrow marked "UP" for down.
(1) If the bullet hits to the right of the aiming point, turn the windage adjustment (clockwise) in the opposite direction of the arrow marked "R" for left as in Fig. 3-5. If the bullet hits
to the left of the aiming point, turn adjustment (counter-clockwise) in the direction of the arrow marked "R" for right.
(1) After the reticle has been adjusted to the point of impacts, with the grip held with your fingers to avoid shifting of the aligned grip, turn the four grip screws around the grip
counterclockwise with Allen wrench. Then lift the grip up and align the "0" with the index mark. And by securing the grip with your fingers to avoid shifting of the grip, turn the
grip screws clockwise with Allen wrench until the grip in firmly secured. (Fig. 3-6)
Fig. 3-6 Fig. 3-5