Nextar SNAP3 - Manual (Page 14)

Global Positioning System
4
Connecting to AC Power and Charging the Battery
For the first time, you should charge it for at least 8 hours.
Follow the 2 steps below to charge the battery.
1. Connect the AC power adapter to the
miniUSB port.
2. Plug the AC adapter into a wall outlet.
The charge indicator glows red when the battery is being charged. Do not disconnect your device from
AC power until the battery is fully charged and the charge indicator turns green. This will take a couple of
hours.
Note
1. Do not immediately turn on your device after connecting the AC
adapter to charge a power-consumed battery. If you need to turn
ON the device again, wait at least one minute.
2. Depending on your region of purchase, the connector converter
may not look exactly same as that in the picture shown above.
3. Your device can also be charged when it is connected to a desktop
computer via a USB cable.
For optimal performance of the lithium battery, bear in mind the following
notes:
1. Do not charge the battery when the surrounding temperature is high
(e.g. in direct sunlight).
2. There is no need to fully discharge the battery before charging. You
can charge the battery before it is discharged.
3. If you will not use the product for a long period of time, be sure to fully
charge the battery at least once in two weeks. Over discharge of the
battery can affect the charging performance.
Caution