Napco Security Technologies GEM-DXRP2 - Manual (Page 26)

26
P R O G R AM M I N G ( O P T I O N A L )
5. Enter the new User Code using the
number buttons. If an old code is
displayed, simply program over it.
To erase the digit at the cursor,
press G , then 0 .
Note: Pressing
A again will dis-
play non-programmable "OPTion" and
"ACCess" screens. Do not attempt to
program these screens as the entries
will not be saved.
6. Press
D
to save the code in mem-
ory. Repeat steps 3-6 for each user.
Note: Duplicate Codes are not allowed;
therefore a duplicate Code entered in
the LCD Window will erase when
D
is pressed.
Note: To void a code, blank out each
digit by pressing
G 0 , then
press the Save (
D
) button.
User 01
To Program User Codes
1. Using Number buttons,
enter User Number
2. Press
A
3. Using number buttons,
enter User Code of up to
6 digits.
4. Press
D
to save.
5. Press
C to Exit Pro-
gram Mode.
Programming User Codes
Note: Press G , 0 to clear
character at cursor.