Nokia DIGITAL MULTIMEDIA TERMINAL - Manual (Page 14)

14
CHAPTER 10 : Update New DMT Software
Your DMT has the capability to be updated over the air. This process may
update certain menu functions and add new features. But don’t worry, the
basic operation of the DMT will remain the same. When the software
update process is initiated, the DMT will search for new software broadcast
by ASTRO. If a newer version of DMT software is being broadcast, the
DMT will automatically update itself. There are additionally 3 ways to
acquire the DMT software update manually.
Through the Main Menu
• While watching ASTRO programmes, press MENU. The main menu screen
will appear.
• Press 1 on the numeric keypad to select the “Installation Setup” option.
• Press 4 on the numeric keypad to select the “Auto update” option.
• Press OK to confirm
• Wait for approximately 5 minutes for your DMT to perform the software
update.
• While your DMT is updating itself, animation on the front panel will appear
to indicate that the update process is in progress.
• Upon completing the software update, the DMT will reset itself.
• If the software update is successful, the DMT will show the last viewed
channel.
Note : Software update will only commence if you are currently running an
older version of software that needs updating. If your DMT software
is already up to date, activating the “Auto update” function will cause
an error message to appear. This is normal.
Switching the Mains AC Power
By switching OFF the mains AC power on the wall socket and then back
ON again, the DMT will automatically perform a software update if neces-
sary, as describe earlier.
Set the DMT to Stand-By-Mode
• Press the Stand-By button.
• While on Stand-By your DMT will automatically perform a software update
as described earlier.
• If a newer version of DMT software is being broadcast, the DMT will auto-
matically update itself. Otherwise, the DMT will remain in Stand-By mode
and the front panel will display the current time.
• While your DMT is updating itself, animation on the front panel will appear
to indicate that the update process is in progress.
• Upon completing the software update, the DMT will reset itself and goes
into Stand-By mode with the current time displayed on the front panel.