Niles Audio SAS-1 - Manual (Page 6)

4
INSTALLATION EXAMPLES USING THE SAS-1
USING AN SAS-1 VIDEO SIGNAL ACTIVATED SWITCH.
FIGURE 1
��������������
�������������
�����
���������������
���������������
���������������
�����������
���������������
���������������
���������������
�����������
�� ������
�����
�������
����
�
�
������
�
�
� � � � � �
�������
�����
����� �����
�������
�������
��
NOTE: IF YOU ARE USING THE SAS-1 TO SIMULTANEOUSLY SWITCH BOTH LINE-LEVEL AUDIO AND
VIDEO SIGNALS, AND WANT THE UNIT TO TRIGGER FROM EITHER SOURCE, MOVE BOTH THE “A”
SWITCH AND THE “V” SWITCH UP. IF YOU WANT THE SAS-1 TO TRIGGER FROM EITHER SPEAKER-
LEVEL OR VIDEO SIGNALS, SLIDE BOTH THE “S” SWITCH AND THE “V” SWITCH UP. IF YOU MOVE
ALL THREE SWITCHES UP, THEN THE SAS-1 WILL TRIGGER FROM ANY OF THE THREE SOURCES
VOLTAGE-ACTIVATED MODE
In this mode, the SAS-1 switches from A to B when 5 to 24 Volts (AC or DC) is applied to the
“CONTROL IN” jack. This is not affected by the settings of the DIP switches
DS00055BCN-0 SAS1.indd 4 4/27/06 4:53:19 PM