Navigon PNA 5100 - Manual (Page 31)

User's manual NAVIGON 5100 | 5110
Routes with stages - 31 -
As soon as you begin navigation, your current location will be used as
the starting point for the route calculation.
The first stage is therefore the trip to the route point with the flow
number "1".
1. Tap on the Specify Starting Point field.
The S
TARTING P OINT
menu opens.
If you want to enter your current location as the starting point:
2. Tap on the Current Position menu item.
If you want to enter a different starting point:
2. Tap the corresponding button.
3. Enter the starting point. (See the corresponding section of chapter
"Navigation" on page 20 ff.)
4. Tap the Set Starting Point button.
The selected starting point will now be displayed next to the
0°(Starting Point) button.
Changing the starting point
►
Tap the Specify Starting Point field.
The S
TARTING P OINT
menu opens. You can now enter a different
starting point. Proceed as described above.
7.1.2 Entering route points
Route points are destinations on the route that you want to navigate to.
The flow number for each route point can be found on a button in front
of it.
1. Tap the Add Route Point field.
The R
OUTE P OINT
menu opens.
2. Tap on the button for the desired destination entry type.
3. Enter the route point. (See the corresponding section of chapter
"Navigation" on page 20 ff.).
4. Tap the Add button.
The selected route point will now be shown next to its flow number.
Repeat these steps for each additional destination that you want to add
to your route.
7.1.3 Editing route points
Route points can be deleted from a route. The order of the route points
can be varied as you wish.