Using standby mode, From the main window, From any navigon 2100 max | 2120 max window – Navigon PNA 2100 max User Manual
Page 41: Switching the device back on from standby
Basic Operations
Starting the NAVIGON 2100 max | 2120 max
December 2008
NAVIGON 2100 max | 2120 max User’s Guide
25
Version 2.1
NAVIGON, INC.
Using Standby Mode
Standby mode conserves battery power. When the device is switched back on from
Standby, the window that displayed when the device was set to Standby re-displays.
There are two ways to switch your device to Standby.
From the Main Window
On the M
AIN
W
INDOW
:
•
Tap the
(Standby) button.
From Any NAVIGON 2100 max | 2120 max Window
•
Press and hold the
(On/Standby/Off) button for two (2) seconds, then
release.
Switching the Device Back On From Standby
To switch the Device back on:
•
Press and hold the
(On/Standby/Off) button for two (2) seconds, then
release.
Note: Use Standby mode only when your device will be unused for a very short time. If
left in Standby mode for an extended period, battery drain can occur as the GPS
receiver continues to draw power. For longer periods of inactivity, see “Turning off the
NAVIGON 2100 max | 2120 max” on page 26.
Note: To further conserve battery power, the device resets itself if left in Standby mode
for a longer time.