Console configuration, Console configuration -35 – Netopia R5300 User Manual
Page 97
WAN and System Configuration 8-35
1.
Select Current Date and enter the date in the appropriate format. Use one- or two-digit numbers for the
month and day, and the last two digits of the current year. The date’s numbers must be separated by
for ward slashes (/).
2.
Select Current Time and enter the time in the format HH:MM, where HH is the hour (using either the
12-hour or 24-hour clock) and MM is the minutes.
3.
Select AM or PM and choose AM or PM.
Note: If you have Connection Budgets configured, changing the date setting will reset the Connection Budgets
under one of the following conditions:
If the new date is greater than the old date and the new date falls outside of the current budget window; or, if
the new date is in the past and the date is not the current date (i.e. yesterday or earlier). A warning message is
displayed in the console window when a budget is reset.
“Connection Budgets page” on page 12-26
for more information.
C
C
C
Co
o
o
on
n
n
nsssso
o
o
ollllee
e
e cccco
o
o
on
n
n
nffffiiiig
g
g
gu
u
u
urrrraa
a
attttiiiio
o
o
on
n
n
n
You can change the default terminal communications parameters to suit your requirements.
To go to the Console Configuration screen, select Console Configuration in the System Configuration screen.
Follow these steps to change a parameter’s value:
1.
Select the parameter you want to change.
2.
Select a new value for the parameter. Return to step 1 if you want to configure another parameter.
3.
Select SET CONFIG NOW to save the new parameter settings. Select CANCEL to leave the parameters
unchanged and exit the Console Configuration screen.
Console Configuration
Baud Rate... 57600
Hardware Flow Control: No
SET CONFIG NOW CANCEL