NEC LT260 - Manual (Page 123)

E-123
TROUBLESHOOTING
This section helps you resolve problems you may encounter while setting up or
using the projector.
Power Indicator
Indicator Condition Projector Condition Note
Off
Blinking light
Steady light
Green blinking
Green blinking
Orange blinking
0.5 sec ON,
0.5 sec OFF
2.5 sec ON,
0.5 sec OFF
0.5 sec ON,
0.5 sec OFF
The main power is off
The projector is getting ready
to turn on.
The projector is in Sleep mode.
The projector is cooling down.
The projector is turned on.
The projector is in Standby or
Idle.
Green
Orange
–
Wait for a moment.
–
Wait for a moment.
–
–
Indicator Condition Projector Condition Note
Off
Blinking light
Steady light
Red blinking
Green blinking
Orange
Green
1 cycle (0.5 sec ON,
2.5 sec OFF)
2 cycle (0.5 sec ON,
0.5 sec OFF)
3 cycle (0.5 sec ON,
0.5 sec OFF)
4 cycle (0.5 sec ON,
0.5 sec OFF)
6 cycle (0.5 sec ON,
0.5 sec OFF)
Normal
Lamp cover error
Temperature error
Power error
Fan error
Lamp error
Re-firing the lamp
Control key locked
Idle condition
–
Replace the lamp
cover correctly.
The projector is
overheated. Move
the projector to a
cooler location.
Power unit will not
work correctly.
Fans will not work
correctly.
Lamp fails to light.
Wait a full minute and
then turn on again.
The projector is re-
firing.
You have pressed
control panel key
when Control Key
Lock is enabled.
–
Status Indicator