NEC E700 - Manual (Page 4)

Quick Start
To attach the MultiSync ® E Series monitor to your system, follow
these instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the MultiSync E Series Macintosh cable adapter (not
included) to the monitor connector on the Macintosh (Figure B.1). Attach the
15-pin mini D-SUB end of the captive signal cable to the Macintosh cable
adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the MultiSync E Series cable adapter, call
NEC Technologies at (800) 820-1230.
4. Connect one end of the power cord to the MultiSync E Series monitor and the
other end to the power outlet (Figure C.1).
5. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User’s Manual.
2
Figure A.1
15-pin mini D-SUB
Captive Signal Cable
78131861 5/21/98, 2:22 PM 4