NEC MULTISYNC LCD195WVXM - Manual (Page 14)

2
LCD Module Diagonal: 9.0 inch Active matrix; thin film transistor (TFT)
Viewable Image Size: 9.0 inch liquid crystal display (LCD); 0.284 mm dot
Native Resolution (Pixel Count): 440 x 900 pitch; 300cd/m 2 white luminence;
700: contrast ratio, typical
Input Signal PC INPUT
Video: ANALOG 0.7 Vp-p/75 Ohms Digital Input: DVI
Sync: Separate sync TTL Level (Positive/Negative)
Horizontal sync Positive/Negative
Vertical sync Positive/Negative
AUDIO INPUT STEREO Mini Jack
500mV rms Input Impedance 4 Kohm
Head Phone Output STEREO Mini Jack
Headphone Impedance 32 Ohm
Display Colors Analog input: 6.2M Depending on display card used.
Maximum Horizontal: 70° (CR>5)
Viewing Angles Vertical: 60° (CR>5)
Synchronization Horizontal: 3.5 kHz to 8. kHz Automatically
Range Vertical: 56 Hz to 76 Hz Automatically
Resolutions Supported 720 x 400* : VGA text Some systems may not support
640 x 480* at 60 Hz to 75 Hz all modes listed.
800 x 600* at 56 Hz to 75 Hz
832 x 624* at 75 Hz
024 x 768* at 60 Hz to 76 Hz
280 x 768* at 60 Hz
52 x 864* at 60 Hz to 75 Hz
52 x 870* at 75 Hz
280 x 960* at 60 Hz to 75 Hz
280 x 024 at 60 Hz to 76 Hz NEC DISPLAY SOLUTIONS cites
360 x 768 at 60 Hz recommended resolution at 60 Hz for
440 x 900 at 60 Hz to 75 Hz ................ optimal display performance.
Active Display Area
Horizontal : 408.2 mm/6. inches
Vertical : 255.2 mm/0.0 inches
Power Supply 00-240 V ~ 50/60 Hz
Current Rating 0.65-0.3A/00-240V
Speakers Practical Audio Output: + watts
Dimensions 440.0 mm (W) x 36.0 mm (H) x 20.0 mm (D)
7.3 inches (W) x 4.2 inches (H) x 8.3 inches (D)
Weight 4.6 kg
0. lbs
Environmental Considerations
Operating Temperature: 5°C to 35°C/4°F to 95°F
Humidity: 0% to 80%
Altitude: 0 to 0,000 Feet
Storage Temperature: -0°C to +60°C/4°F to 40°F
Humidity: 0% to 85%
Altitude: 0 to 40,000 Feet
Monitor MultiSync
Specifications LCD195WVXM Notes
1940WCXM
* Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear
different. This is normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel
technologies, each dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution
must be done.
NOTE: Technical specifications are subject to change without notice.
Specifications