Nextar X3-05 - Manual (Page 19)

18
When using the unit in vehicle, you can use the supplied mount accessories (mount
bracket, mount cradle and dashboard mount disk) to mount the unit in the vehicle. Take
the following steps to operate:
1. See Fig. 1. According to the arrow to slide the mount cradle to fix it to the mount
bracket.
2. See Fig. 2. First, set the bottom edge of the unit onto the mount cradle. Then press
the two buttons in arrow ① direction and meanwhile push the mount cradle
forwards to embed it in the unit.
3. See Fig. 3. Lift the suction cup lever and then press the suction cup to the
windshield. According to arrow ① to press down the suction cup lever. Then
rotate the knob to adjust the unit to proper position.
To mount to dashboard, use the included adhesive disk. Choose a clean, dry spot
on your dashboard, peel off protection liner from the back of the disk, and then
attach the disk to your dashboard.
Warning:
When you mount the device in your vehicle, ensure it has a clear line of sight to the sky.
The device must not be mounted so that it impairs the driver’s view of the road. Please
take extra precaution to ensure the airbags are not obstructed by the device.
Use of the Mount
Accessories