Connecting your pc or macintosh computer, To connect scart output (rgb), E-16 – NEC HT1100 User Manual

Page 16

Advertising
background image

E-16

Connecting Your PC or Macintosh Computer

PC CONTROL

COMPUTER IN

DVI-D IN

SG TRIGGER

VIDEO IN

S-VIDEO IN

S-VIDEO

S-VIDEO

RGB/DVI

RGB/DVI

VIDEO

VIDEO

AUDIO IN

AUDIO IN

COMPONENT

Y

Cb/Pb

Cr/Pr

PHONE

AUDIO IN

PHONE

COMPUTER

Audio cable (not supplied)

IBM VGA or Compatibles (Notebook type)
or Macintosh (Notebook type)

IBM VGA or Compatibles (Desktop type)
or Macintosh (Desktop type)

RGB signal cable (supplied)
To mini D-Sub 15-pin connector on the projector. It is recommended
that you use a commercially available distribution amplifier if con-
necting a signal cable longer than the supplied one.

NOTE: For older Macintosh, use
a commercially available pin
adapter (not supplied) to con-
nect to your Mac's video port.

Connecting your PC or Macintosh computer to your projector will en-
able you to project your computer's screen image for an impressive pre-
sentation.
To connect to a PC or Macintosh, simply:

1. Turn off the power to your projector and computer.

2. Use the supplied signal cable to connect your PC or Macintosh to the

projector.

3. Turn on the projector and the computer.

4. If the projector goes blank after a period of inactivity, it may be caused

by a screen saver installed on the computer you've connected to the
projector.

NOTE: The HT1100 is not compatible with video decoded outputs of NEC ISS-
6020 and ISS-6010.

For European model only

To connect SCART output (RGB)

Before connections: The supplied SCART adapter (ADP-SC1) and a
commercially available SCART cable are required for this connection.

NOTE: Audio signal is not available for this connection.

SE

LE

CT

C

N

A

C

EL

TE

R

N E

E

M

NU

SOURCE

AUT

O ADJUST

ON

STAND

BY

ST

AT

US

PO

WE

R

LA

MP

ALIGNMENT

PC

-C

AR

D

Video equipment
such as DVD player

Projector

SCART adapter
ADP-SC1 (supplied)

Commercially available
SCART cable

1. Turn off the power to the projector and your video equipment.

2. Use the supplied SCART adapter and a commercially available

SCART cable to connect the COMPUTER input of your projector and
a SCART output (COMPUTER) of your video equipment.

3. Turn on the power to the projector and your video equipment.

4. Use the COMPUTER button on the remote control to select the COM-

PUTER input.

5. Press the MENU button on the remote control to display the menu.

6. From the Advanced menu, select [Setup]

[Page 2]

[Signal Se-

lect]

[Computer]

[Scart].

SCART is a standard European audio-visual connector for TVs, VCRs
and DVD players. It is also referred to as Euro-connector.

To COMPUTER IN

NOTE: An image may not be displayed correctly when a Video or S-Video source
is played back via a commercially available scan converter.
This is because the projector will process a video signal as a computer signal at
the default setting. In that case, do the following.

* When noise appears on the sides of the screen:

Use the Overscan feature to display the image correctly.
Be sure to change the Overscan to 0% before pressing the AUTO ADJ or
AUTO ADJUST button. Unless otherwise an image may be displayed with its
sides cut off.

Advertising