Install the drivers – National Instruments Gigabit Ethernet Adapters User Manual
Page 3
© National Instruments Corporation
3
PCI/PXI Gigabit Ethernet Adapters Installation Guide
Caution
If using less than 4-pair cabling, you must manually configure the speed and
duplex setting of the adapter and the link partner. In addition, with 2- and 3-pair cabling,
the adapter can achieve speeds of up to only 100 MB/s.
•
For 10BaseT, use Category 3 wiring or better.
•
To use this adapter in a residential environment (at any speed), use
Category 5 wiring. If the cable runs between rooms or through
walls and/or ceilings, it should be plenum rated for fire safety.
•
The cable length is limited to 100 m.
•
The adapter must be connected to a compatible link partner,
preferably set to auto-negotiate speed and duplex.
•
The PCI-8232 and PXI-8231/8232 automatically accommodate
either MDI or MDI-X connections. The auto-MDI-X feature
allows you to directly connect two adapters without using a
crossover cable.
2.
To configure Ethernet for your adapter, continue with the procedure
specific to your operating system outlined later in this guide.
Install the Drivers
Follow the installation instructions for your operating system. The adapter
works with the following operating systems:
•
•
•