NuTone QTXEN080FLT - Manual (Page 4)

Page 4
MODELS QTXEN080FLT • QTXEN110FLT • QTXEN150FLT
SERVICE PARTS
99044460A
Key No. Part No. Description
1 97016466 Housing
2 97016450 Duct Connector - 6”
3 98010102 Wiring Plate
4 99170245 Screw, #8-18 X .375
5 97018011 Wire Panel/Harness Assembly
6 97017850 Blower Assembly (QTXEN080FLT)
97017851 Blower Assembly (QTXEN110FLT)
97016591 Blower Assembly (QTXEN150FLT)
7 97018272 Grille Assembly (includes key nos. 8, 9 &10)
8 99140199 Grille Spring (2 req’d)
9 99111400 Lens
10 99271381 Bulb, GU24, 18W Fluorescent, (2 req’d)
11 99420665 Thumbscrew, #8-18 x .375
12 97018014 Spacer (2 supplied)
13 QTNHB1 Hanger Bar Kit
Order service parts by “Part No.” - not by “Key No.”
INSTALL GRILLE
5. Finish ceiling.
Install ceiling material. Cut out around housing.
6. Attach
grille to
housing.
Squeeze
grille springs
and insert
them into
tabs on each
side of hous-
ing.
8. Remove
light
lens.
Carefully in-
sert a small
flat-blade
screwdriver
between
grille and
lens. Pry
lens out.
7. Push
grille
against
ceiling.
9. Install
light
bulbs.
Fluores-
cent bulbs
supplied.
Purchase a
4W incan-
descent
night-light
bulb. Insert
bulbs into
their sockets. Replace lens.
SERVICE NOTE To remove Blower
Assembly: Unplug motor. Remove
thumbscrew (11) from motor plate
flange. Find the single TAB on
the motor plate (located next to
the receptacle). Push up near
motor plate tab while pushing out
on side of housing. Or insert a
straight-blade screwdriver into slot
in housing (next to tab) and twist
screwdriver.
Replacement parts can be or-
dered on our website. Please
visit us at www.nutone.com