Nady Systems MSE-100A - Manual (Page 6)

10. INPUTS
The MSE-100A is equipped with both 1/4” (6.3mm) TRS and XLR audio input jacks. These can be used for either bal-
anced or unbalanced operation as follows:
• Unbalanced use of mono 1/4” plugs:
Tip = Signal, Sleeve = Ground / Shield.
• Balanced use of TRS stereo 1/4” plugs:
Tip = hot (+), Ring = cold (-), Sleeve = Ground / Shield.
• Balanced use with XLR connectors:
1 = Ground / Shield, 2 = hot (+), 3 = cold (-).
11. OUTPUTS
The audio outputs of the MSE-100A are matching phone jack and XLR connectors wired in parallel.
• Balanced use of stereo 1/4” jack/plugs:
Tip = hot (+), Ring = cold (-), Sleeve = Ground / Shield
• Balanced use with XLR connectors:
1 = Ground / Shield, 2 = hot (+), 3 = cold (-).
12. FUSE HOLDER
The IEC power socket has an integral fuse holder that takes a 20mm fuse.
NOTE: Always replace a blown fuse with the same type as specified on the rear of the unit.
13 . POWER CONNECTION
A standard IEC AC power socket for connecting to the main AC supply.
Note: Before you connect your Enhancer to the AC, please make sure that your local voltage matches the voltage re-
quired by the unit!
Note: Do not remove the center ground conductor.
14 . VOLTAGE SELECTOR SWITCH
For selecting the proper voltage (115/230VAC) to match the power supply in your area.
7
14
13
12 11
REAR PANEL CONTROLS AND CONNECTIONS
10 11 10